Flag With Rope And Toggle

1 2 cm end diameter.

Flag with rope and toggle.

You want to create an endless length of halyard. Push the toggle through the loop that was made in the halyard and make sure it is secure. Attach your snap hook to the halyard by making a loop in the rope. Stretch the flag down the rope to measure where the bottom snap hook should be placed.

If you are flying the union jack flag it is important that your display it the correct way up. The flag should form part of a continuous loop with the halyard rope on the flagpole. 5 7 cm center width. If the flag is fitted with a toggle this will normally be fitted at the top of the flag.

Flags with grommets these are round and solid brass that are placed usually on the header of the flag one at the top and one at the bottom. Pull the hook part through the loop and tighten the rope to the body of the hook. The toggle denotes the top of the flag and a short length of line or rope comes out of the bottom of the flag heading. The flag should be attached to its left hand side with a heading line and toggle.

Rope toggle for 18 x 36 flags toggle specs. The small loop will grow tighter with each pull of the halyard.